Salt lamp 5 kg.

Weight: ~5 kg.

Height: 26-30 cm.

Light source: bulb E14, 15w (included)

Electric cord length: 150 cm.

ATTENTION! The salt lamp is made by hand from natural material (rock salt), so the appearance, weight and dimensions of each product are different.

The usage of lamps
Salt lamps are intended for indoor use only. Salt crystals have high hygroscopic properties, i.e. their attract water molecules from the atmosphere, so that they should be used in dry rooms. If the humidity in the room increases, e.g. during rain, the lamp should be switched on. By heating the salt crystal by the bulb inside, the water molecules evaporate from the surface of the crystal..
Warning! If the lamp is to be stored in damp conditions for a longer time (e.g. in a garage, in the trunk of during rain, etc.), the lamp shall be secured with a tightly sealed foil bag.

Using lamps in rooms and offices
While using salt lamps in those places one shall pay attention to few rules. Firstly, if the lamp is damp, the water condensing on the surface of the crystal may drip onto the surface, on which the lamp is placed and this may cause the damage to such surface (e.g. discoloration or warping of the wooden surface of the furniture). By placing a lamp on surfaces that may be damaged (e.g. antique furniture), one shall place additional surface protection under the lamp (such as a waterproof plastic napkin, cork stand etc.). Above all, one shall keep in mind that if the humidity increases the lamp shall be switched off. Secondly, if there are small children and pets in rooms where the salt lamps are located, one shall avoid placing lamps on the edges of the furniture and in such a way that the lamp's electrical wire will be out of the reach of a child. The lamp shall be placed in such a way that there is no risk of falling down.

Pets
Sometimes pets (especially dogs) instinctively lick a lamp to supplement minerals in their bodies. A salt lamp is not intended for consumption; however, it consists of 100% natural salt, and therefore it is not harmful to pets.

Light bulb replacement
WARNING!!! BEFORE UNDERTAKING ANY ACTIVITIES LISTED BELOW, UNPLUG LAMP FROM POWER SOURCE!

1. Take off a frame and pry off a metal base of a spring holding a frame using a sharp tool.
2. When a frame and a spring are taken out from a salt lump, replace a light bulb.
3. Place a frame and a spring back in the salt lump.
4. Put a lamp in a working position and plug it to power source.
5. If a lamp does not work after a bulb replacement, contact a vendor.
6. In case of damaging a connecting cable, it is possible to replace it only in the technical service through the lamp vendor.